Pantech WV-NW474S Manuel d'utilisateur télécharger pdf (Page 38)

-38-

• Click the [SET & REBOOT] button.

Note: Wait for around 10 seconds until rebooting is

completed.

Note: Sending E-mails will not be possible in an envi-

ronment where POP (Post Office Protocol) authenti-

cation is required.

7. External Alarm Reset

• Click the [Alarm Reset] button to cancel the activat-

ed alarm.

Note: Input an external alarm signal of more than

100 ms.

■ FTP Client Setup

Image files can be transferred to the FTP server within

the scheduled time zone.

1. Open the FTP Client Setup window.

2. Common Setup

• Enter the FTP server address.

A hostname.domainname can be entered when

using the DNS function.

• Enter the user name in up to 16 characters.

• Enter user name and password in up to 16 char-

acters to access the FTP server.

• Select Sequential or Passive as the transmission

mode. Passive is recommended when

Sequential does not perform properly.

• Complete schedule 1 and 2 by specifying the

transmission time zone and the day of the week.

3. Non-Alarm (FTP) Image Transmission Setup

• Select ON or OFF to transmit ordinary image files

except in an alarm condition.

ON: Transmits files when a scheduled time

comes.

OFF: Does not transmit, and no schedule is

applied.

• Enter the receiver directory. The column should

not be empty.

• Enter the file name and click FIX or DATE.

FIX: Uses repeatedly a single file name when

overwriting new data.

DATE: Creates and attaches a serial number

and a date-and-time to the entered file name.

• Select the transmission interval by pressing the

[

o] button.

Available times (seconds): 0.2 - 0.9, 1 - 1 440

Available times (minutes): 1 - 1 440

Notes:

• The transmission may be longer due to the net-

work speed and/or traffic conditions.

• An alarm image precedes a non-alarm image in

transmission to the FTP server. The non-alarm

image may not be sent when alarm activations

frequently arise.

4. Alarm (FTP) Image Transmission Setup

The alarm setup window specifies the profile of the

file transmission such as the number of files and the

frame rate (fps).

• Select ON or OFF to transmit the image files.

ON: Transmits the files when alarm arises.

OFF: Does not transmit.

• Enter the receiver directory. The column should

not be empty.

• Enter the file name. The column should not be

empty.

5. Click the [SET & REBOOT] button.

Note: Wait for around 10 seconds until rebooting is

complete.

Note: Set the file system on the FTP server to the

UNIX mode when using the FTP client function.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Pantech WV-NW474S Manuel d'utilisateur Page 38

Commentaires sur ces manuels