Pantech WV-NW474S Manuel d'utilisateur télécharger pdf (Page 13)

-13-

● Video Output Connection

Connect the video output cable to the monitor or other

system device with the procured coaxial cable. The

maximum extensible length is shown in the table.

● Control Connector

Connect the respective peripherals to supply and

receive control signals. Use the supplied 5-pin cable

adapter. For electrical ratings, refer to SPECIFICA-

TIONS.

● Network Port Connection

Connect the network port to a PC or a network via a

hub with a 10BASE-T/100BASETX cable. Use the sup-

plied adapter (RJ-45, female-female) if necessary.

Note: For network system connections, refer to ■

Network Connection Types.

Type of RG-59/U RG-6/U RG-11/U RG-15/U

coaxial cable (3C-2V) (5C-2V) (7C-2V) (10C-2V)

Recommended (m) 250 500 600 800

maximum

cable length (ft) 825 1 650 1 980 2 640

Alarm out

Wire color Function

Example of

peripherals

Black1 Alarm in Door switch

Gray2 Buzzer

Pink3 AUX out Lighting lamp

Red4 Day/night in Optical sensor

Green5 GND Signal ground

Pin#

■ Image Adjustment

You can manually adjust the pan/tilt/azimuth angles,

focus, and zoom while observing the connected moni-

tor.

Notes:

• Do not hold the camera by the lens unit when

adjusting panning, tilting, or azimuth.

• The video output to the BNC will be interrupted while

an LCD monitor is connected to the monitor output

jack.

1. Connect an LCD monitor to the video jack.

2. Pan/tilt/azimuth adjustment

• Loosen the two screws locking the pan and tilt

tables.

• Pan and tilt the table to aim the camera at what you

need to watch.

• Turn the azimuth adjuster to obtain a level image.

• Tighten the two screws after adjustment.

Pan lock screw

Panning table

Variable angles

plus or minus 75°

(max.)

Monitor

output jack

Azimuth adjuster

Tilting lock screw

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Pantech WV-NW474S Manuel d'utilisateur Page 13

Commentaires sur ces manuels